Mirror heating 483 x 410 mm

Art. no.
400100

Prevent condensation on the mirror, easy to apply (self-adhesive), 33 Watt, 230 Volt

More information
€65.95
per piece
Delivery: 1-3 working days

With a mirror heating you prevent condensation on your mirror. The heating pad heats the surface of the mirror so that water vapor will not settle on this warm part of the mirror. The mirror heating only heats the part where the heating pad is behind with an edge around 5 - 7 cm. That is also sufficient because ultimately you want part of the mirror to be condensation-free so that you can see yourself in the mirror. The entire mirror does not have to be condensation-free for this.

The heating pad does need space at the back so that the residual heat can be dissipated. It is therefore not a good idea to completely enclose / integrate / glue a heating system. It is best to place the mirror heating pad in combination with a blind mounting set.

 

Main features of the mirror heating 483 x 410 mm:

tick-marks  Prevents condensation on the mirror
tick-marks  Ideally suited for damp areas such as a bathroom (IPx4 certification)
tick-marks  Self-regulating so no thermostat required
tick-marks  Easy to apply (self-adhesive)
tick-marks  Suitable for mirrors without safety film
tick-marks  Connection: directly to the bathroom light switch
tick-marks  Preferably used in combination with a blind mirror mounting set
tick-marks  Size 48.3 x 41 cm
tick-marks  Thickness of the pad is approx. 1 mm
tick-marks  Thickness of the connection point from the pad to the cord of the mat: approx. 8 mm (at least 8 mm space behind the mirror is required !!)

 

This mirror heating 483 x 410 mm comes with:

tick-marks  1 mat of 483 x 410 mm (48.3 x 41 cm)
tick-marks  2-core connection cable of approx. 88 cm long
tick-marks  An installation manual

 

Points of attention:

tick-marks  Do not cut the heating, it cannot be cut to size
tick-marks  Stick the heating pad on that part that you want condensation-free, measure this well in advance
tick-marks  The heating pad must not be in direct contact with mounting materials such as the blind mirror mounting kit
tick-marks  Tiling, plastering, gluing or otherwise enclosing the heating is not wise. Accumulating residual heat can cause the mirror to break over time
tick-marks  The heating pad is self-adhesive. This adhesive layer is quite strong. Stick the heating pad on well in 1 go
tick-marks  You connect the heating pad to the light point behind your mirror. This light fixture is operated with the light button of the bathroom, which you normally use to operate the lighting above the sink. There is no separate on / off switch on the heating pad itself. So you are completely dependent on the control from your fixed switch of the bathroom
tick-marks  Don´t connect the heating pad to a light dimmer, the heating will not work properly on a dimmer switch

More Information
Art. no.400100
Dimension483 x 410 mm
Usage33 Watt
Voltage230 V
Safety ClassIPx4 (protection against water and for use in wet areas)
Other standardsSupplied according to CE standard, Kema Keur and the European standard EN60335-1 / EN60335-2-96
BrandPGV
Packed in abox
Scope of supplyper 1 piece
Unit of measurementper piece
Expected delivery time1-3 working days
Shipping price Netherlands9,25
Shipping price Belgium12,75
Shipping price rest of EuropeSee the check-out page for actual pricing
Pick-up possible? (without costs)Yes, Pick-up is possible in:, 's-Hertogenbosch
Write Your Own Review
You're reviewing:Mirror heating 483 x 410 mm
Customer Questions
No Questions

test Engels

We found other products you might like!