Glass clamp MOD4200, flat mounting, RAL9005 matt black structure
Glass clamp for indoor and outdoor use, Zamak, glass thickness 6 - 12.76 mm
(more information)- Free shipment from € 500,- (incl. VAT)
- Pick-up in NL or delivery in NL and Flanders (exception of the Wadden Islands)
- Relatively short delivery times
- Pay with i.e. iDeal, Riverty, Billink, Bancontact, PayPal en Creditcard
Glass clamp type MOD 4200, flat mount (matt black) is a Zamak glass clamp suitable for indoor and outdoor use (by coastal areas the salt can have influence on the clamp). This clamp is ideal for mounting tempered glass, laminated glass and tempered-laminated glass panels between posts. It is delivered with a locking plate as standard. This plate is located inside the clamp and can be easily removed to create an open clamp. The locking plate supports the glass panel to prevent it from sliding out of the clamp.
Optionally, you can order a safety pin. This pin can only be used if a pre-drilled hole in the glass has been accounted for during the glass ordering process.
No additional cutouts in the glass are required for this glass clamp. As a result, there is a gap of approximately 20 mm between the glass and the post. If you are looking for a clamp for a shower wall, we recommend ordering a dedicated shower wall clamp instead of this one.
Features glass clamp MOD 4200, flat mount, RAL9005 matt black structure:
- Glass clamp for mounting mounting tempered glass, laminated glass and tempered-laminated glass
- Mounting on a flat surface
- Suitable for glass thickness: 6 - 12.76 mm
- Designed for indoor and outdoor use (salty air in coastal areas can have influence on the material of the clamp)
- Made of Zamak, powder-coated in RAL9005 matt black structure
- Includes a removable locking plate, enabling an open bottom configuration
- Glass deduction: 20 mm on each side where the clamp is placed
- Dimensions: 45 x 28 x 57 mm
- Available per unit; the stated price is a unit price!
Glass clamp type MOD 4200, flat mount, RAL9005 matt black structure comes with:
- One glass clamp
- Two hex screws for securing the clamp to the glass
- One removable locking plate
- One gasket set for the selected glass thickness (2 separate gaskets)
Points of attention:
- Use the correct screws for your situation (these are not supplied with the clamp) screw
- Open the clamp, mount the clamp on the upright / wall, position the glass in the correct place and clamp it with the Allen screws (use the correct thickness mounting gasket)
- A safety pin can be ordered optionally. This requires a pre-drilled hole in the glass, which must be specified when ordering the glass. The required hole diameter is detailed in the product "safety pin"
- Work carefully and use the proper tools
- Preferably use a long spirit level or a laser level for precise positioning of the clamps
- Ensure you apply the correct glass deduction when ordering the glass panel. Contact us for advice if needed
- Make sure that when ordering the glass you indicate whether you are going to use the securing pin. You cannot drill into the glass afterwards
- Never rest glass directly on the floor. Always place a protective layer, such as a wooden strip, blanket, or carpet, underneath. Placing glass on a hard surface increases the risk of damage. The same applies to contact with walls or other hard surfaces. Protect the glass, as it remains a fragile product
- You are fully responsible for selecting the correct materials to meet the required standards. This applies to both the glass (i.e. thickness, size and specifications) and the mounting materials