Mirror heating 524 x 1024 mm

Prevent condensation on the mirror, easy to apply (self-adhesive), 100 Watt, 230 Volt

(more information)
Art. no.
234109
€65.75
per piece
Delivery: 1 - 3 working days
  • Free shipment from € 500,- (incl. VAT)
  • Pick-up in NL or delivery in NL and Flanders (exception of the Wadden Islands)
  • Relatively short delivery times
  • Pay with i.e. iDeal, Riverty, Billink, Bancontact, PayPal en Creditcard

With a mirror heating you prevent condensation on your mirror. The heating pad heats the surface of the mirror so that water vapor will not settle on this warm part of the mirror. The mirror heating only heats the part where the heating pad is behind with an edge around 5 - 7 cm. That is also sufficient because ultimately you want part of the mirror to be condensation-free so that you can see yourself in the mirror. The entire mirror does not have to be condensation-free for this.

The heating pad does need space at the back so that the residual heat can be dissipated. It is therefore not a good idea to completely enclose / integrate / glue a heating system. It is best to place the mirror heating pad in combination with a blind mounting set.

 

Features of the mirror heating 524 x 1024 mm:

  • Prevents condensation on the mirror
  • Ideally suited for damp areas such as a bathroom (IPx4 certification)
  • Self-regulating so no thermostat required
  • Easy to apply (self-adhesive)
  • Suitable for mirrors without safety film
  • Connection: directly to the bathroom light switch
  • Preferably used in combination with a blind mirror mounting set
  • Size 52.4 x 102.4 cm
  • Thickness of the pad is approx. 1 mm
  • Thickness of the connection point from the pad to the cord of the mat: approx. 8 mm (at least 8 mm space behind the mirror is required !!)

 

Mirror heating 524 x 1024 mm comes with:

  • 1 mat of 524 x 1024 mm (52.4 x 102.4 cm)
  • 2-core connection cable of approx. 88 cm long
  • An installation manual

 

Points of attention:

  • Do not cut the heating, it cannot be cut to size
  • Stick the heating pad on that part that you want condensation-free, measure this well in advance
  • The heating pad must not be in direct contact with mounting materials such as the blind mirror mounting kit
  • Tiling, plastering, gluing or otherwise enclosing the heating is not wise. Accumulating residual heat can cause the mirror to break over time
  • The heating pad is self-adhesive. This adhesive layer is quite strong. Stick the heating pad on well in 1 go
  • You connect the heating pad to the light point behind your mirror. This light fixture is operated with the light button of the bathroom, which you normally use to operate the lighting above the sink. There is no separate on / off switch on the heating pad itself. So you are completely dependent on the control from your fixed switch of the bathroom
  • Don´t connect the heating pad to a light dimmer, the heating will not work properly on a dimmer switch